Direct fabrication of a Ti-47Al-2Cr-2Nb ally by selective laser melting and direct metal deposition processes - Archive ouverte HAL Accéder directement au contenu
Communication Dans Un Congrès Advanced Materials Research Année : 2010

Direct fabrication of a Ti-47Al-2Cr-2Nb ally by selective laser melting and direct metal deposition processes

(1) , (2) , (2) , (1) , , , , (3) , (4) , (4) , (4)
1
2
3
4

Résumé

A Ti-47Al-2Cr-2Nb (at.%) material was fabricated using two laser-based methods, “Selective Laser Melting” (SLM) and “Direct Metal Deposition” (DMD), for potential uses in aircraft jet engines. Experiments were conducted under controlled atmosphere by changing the processing parameters. Optimal parameters were searched for this relatively low ductility material to prevent cracking due to built-up residual stresses during fast cooling. It was observed that these non-equilibrium cooling conditions were fast enough to generate ultra fine and metastable structures exhibiting high microhardness values. Post heat-treatments were successfully used to restore homogeneous lamellar or duplex microstructures and to relieve the residual stresses. A comparison of these two methods is provided in terms of powder requirements and of process parameters to achieve noncracked structures and fully dense materials.
Fichier non déposé

Dates et versions

hal-00448707 , version 1 (19-01-2010)

Identifiants

Citer

Thomas Vilaro, V. Kottmann-Rexerodt, M. Thomas, Christophe Colin, Pierre Bertrand, et al.. Direct fabrication of a Ti-47Al-2Cr-2Nb ally by selective laser melting and direct metal deposition processes. Thermec 2009, Aug 2009, Berlin, Germany. pp.586-591, ⟨10.4028/www.scientific.net/AMR.89-91.586⟩. ⟨hal-00448707⟩
261 Consultations
0 Téléchargements

Altmetric

Partager

Gmail Facebook Twitter LinkedIn More