D. U. Shah, P. J. Schubel, and M. J. Clifford, Can flax replace E-glass in structural composites? A small wind turbine blade case study, Composites Part B: Engineering, vol.52, pp.172-181, 2013.
DOI : 10.1016/j.compositesb.2013.04.027

D. Basu, A. N. Banerjee, and A. Misra, Comparative rheological studies on jute-fiber- and glass-fiber-filled polypropylene composite melts, Journal of Applied Polymer Science, vol.46, issue.11, pp.1999-2009, 1992.
DOI : 10.1002/app.1992.070461112

H. A. Barnes, A review of the rheology of filled viscoelastic systems, Rheol. Rev, pp.1-36, 2003.

S. Mohanty, S. K. Verma, and S. K. Nayak, Rheological characterization of PP/jute composite melts, Journal of Applied Polymer Science, vol.4, issue.4, pp.1476-1484, 2006.
DOI : 10.1002/app.22661

H. Azizi and I. Ghasemi, Investigation on the dynamic melt rheological properties of polypropylene/wood flour composites, Polymer Composites, vol.45, issue.4, pp.429-435, 2009.
DOI : 10.1002/pc.20573

E. Twite-kabamba, A. Mechraoui, and D. Rodrigue, Rheological properties of polypropylene/hemp fiber composites, Polymer Composites, vol.47, issue.10, pp.1401-1407, 2009.
DOI : 10.1002/pc.20704

L. Moigne, N. , M. Van-den-oever, and T. Budtova, Dynamic and capillary shear rheology of natural fiber-reinforced composites, Polymer Engineering & Science, vol.41, issue.12, pp.2582-2593, 2013.
DOI : 10.1002/pen.23521
URL : https://hal.archives-ouvertes.fr/hal-00800842

H. Sojoudiasli, M. Heuzey, and P. J. Carreau, Rheological, morphological and mechanical properties of flax fiber polypropylene composites: influence of compatibilizers, Cellulose, vol.77, issue.5, pp.3797-3812, 2014.
DOI : 10.1007/s10570-014-0375-3

J. P. Greene, Steady-State and dynamic properties of concentrated fiber-filled thermoplastics, Polymer Engineering and Science, vol.30, issue.21, pp.1670-1681, 1995.
DOI : 10.1002/pen.760352103

J. Thomasset, P. J. Carreau, B. Sanschagrin, and G. Ausias, Rheological properties of long glass fiber filled polypropylene, Journal of Non-Newtonian Fluid Mechanics, vol.125, issue.1, pp.25-34, 2005.
DOI : 10.1016/j.jnnfm.2004.09.004

A. P. Eberle, D. G. Baird, and P. Wapperom, Rheology of Non-Newtonian Fluids Containing Glass Fibers:?? A Review of Experimental Literature, Industrial & Engineering Chemistry Research, vol.47, issue.10, pp.3470-3488, 2008.
DOI : 10.1021/ie070800j

V. Hristov and J. Vlachopoulos, Influence of Coupling Agents on Melt Flow Behavior of Natural Fiber Composites, Macromolecular Materials and Engineering, vol.125, issue.5, pp.608-619, 2007.
DOI : 10.1002/mame.200600459

L. Moigne, N. , M. V. Oever, and T. Budtova, A statistical analysis of fibre size and shape distribution after compounding in composites reinforced by natural fibres, Composites Part A: Applied Science and Manufacturing, vol.42, issue.10, pp.1542-1550, 2011.
DOI : 10.1016/j.compositesa.2011.07.012
URL : https://hal.archives-ouvertes.fr/hal-00617421

L. Duc, A. , B. Vergnes, and T. Budtova, Polypropylene/natural fibres composites: Analysis of fibre dimensions after compounding and observations of fibre rupture by rheo-optics, Composites Part A: Applied Science and Manufacturing, vol.42, issue.11, pp.1727-1737, 2011.
DOI : 10.1016/j.compositesa.2011.07.027
URL : https://hal.archives-ouvertes.fr/hal-00623531

K. Charlet, J. P. Jernot, S. Eve, M. Gomina, and J. Br-eard, Multi-scale morphological characterisation of flax: From the stem to the fibrils, Carbohydrate Polymers, vol.82, issue.1, pp.54-61, 2010.
DOI : 10.1016/j.carbpol.2010.04.022

K. Charlet, J. P. Jernot, J. Br, and M. Gomina, Scattering of morphological and mechanical properties of flax fibres, Industrial Crops and Products, vol.32, issue.3, pp.220-224, 2010.
DOI : 10.1016/j.indcrop.2010.04.015

J. Gassan, Calculation of elastic properties of natural fibers, Journal of Materials Science, vol.36, issue.15, pp.3715-3720, 2001.
DOI : 10.1023/A:1017969615925

C. Baley, Analysis of the flax fibres tensile behaviour and analysis of the tensile stiffness increase, Composites Part A: Applied Science and Manufacturing, vol.33, issue.7, pp.939-948, 2002.
DOI : 10.1016/S1359-835X(02)00040-4

K. Charlet, J. P. Jernot, S. Eve, M. Gomina, and J. Br-eard, Tensile deformation of a flax fiber, Procedia Engineering, vol.1, issue.1, pp.233-236, 2009.
DOI : 10.1016/j.proeng.2009.06.055

L. H. Switzer and D. J. Klingenberg, Rheology of sheared flexible fiber suspensions via fiber-level simulations, Journal of Rheology, vol.47, issue.3, pp.759-778, 2003.
DOI : 10.1122/1.1566034

M. Keshtkar, M. C. Heuzey, and P. J. Carreau, Rheological behavior of fiber-filled model suspensions: Effect of fiber flexibility, Journal of Rheology, vol.53, issue.3, pp.631-650, 2009.
DOI : 10.1122/1.3103546

R. J. Kerekes, R. M. Soszynski, and P. A. Tam-doo, The flocculation of pulp fibres, papermaking raw materials, Transactions of the Eighth Fundamental Research Symposium held at Oxford, pp.265-310, 1985.

C. P. Bennington, R. J. Kerekes, and J. R. Grace, The yield stress of fibre suspensions, The Canadian Journal of Chemical Engineering, vol.67, issue.3, pp.748-756, 1990.
DOI : 10.1002/cjce.5450680503

L. H. Bos, J. M?, and M. J. , Mechanical properties of short-flax-fibre reinforced compounds, Composites Part A: Applied Science and Manufacturing, vol.37, issue.10, pp.1591-1604, 2006.
DOI : 10.1016/j.compositesa.2005.10.011

J. Ganster and H. Fink, Novel cellulose fibre reinforced thermoplastic materials, Cellulose, vol.92, issue.3, pp.271-280, 2006.
DOI : 10.1007/s10570-005-9045-9

P. R. Hornsby, E. Hinrichsen, and K. Tarverdi, Preparation and properties of polypropylene composites reinforced with wheat flax straw fibres, Part II: Analysis of composites microstructure and mechanical properties, Journal of Materials Science, vol.32, issue.4, pp.1009-1015, 1997.
DOI : 10.1023/A:1018578322498

B. Franzèn, C. Klason, J. Kubat, and T. Kitano, Fibre degradation during processing of short fibre reinforced thermpolastics, pp.65-75, 1989.

M. Akay and D. Barkley, Fibre orientation and mechanical behaviour in reinforced thermoplastic injection mouldings, Journal of Materials Science, vol.7, issue.2, pp.2731-2742, 1991.
DOI : 10.1007/BF02387744

S. Fu, X. Hu, and C. Yue, EFFECTS OF FIBER LENGTH AND ORIENTATION DISTRIBUTIONS ON THE MECHANICAL PROPERTIES OF SHORT-FIBER-REINFORCED POLYMERS, Journal of the Society of Materials Science, Japan, vol.48, issue.6Appendix, pp.74-83, 1999.
DOI : 10.2472/jsms.48.6Appendix_74

U. Yilmazer and M. Cansever, Effects of processing conditions on the fiber length distribution and mechanical properties of glass fiber reinforced nylon-6, Polymer Composites, vol.36, issue.1, pp.61-71, 2002.
DOI : 10.1002/pc.10412

T. Kitano, T. Kataoka, and Y. Nagatsuka, Shear flow rheological properties of vinylon- and glass-fiber reinforced polyethylene melts, Rheologica Acta, vol.134, issue.1, pp.20-30, 1984.
DOI : 10.1007/BF01333872

A. D. Drozdov, A. Mulla, and R. K. Gupta, The viscoelastic and viscoplastic behavior of polymer composites: polycarbonate reinforced with short glass fibers, Computational Materials Science, vol.28, issue.1, pp.16-30, 2003.
DOI : 10.1016/S0927-0256(03)00058-2

C. Mobuchon, P. J. Carreau, M. C. Heuzey, M. Sepehr, and G. Ausias, Shear and extensional properties of short glass fiber reinforced polypropylene, Polymer Composites, vol.22, issue.3, pp.247-264, 2005.
DOI : 10.1002/pc.20088
URL : https://hal.archives-ouvertes.fr/hal-00455439

R. Guo, J. Azaiez, and C. Bellehumeur, Rheology of fiber filled polymer melts: Role of fiber-fiber interactions and polymer-fiber coupling, Polymer Engineering & Science, vol.429, issue.3, pp.385-399, 2005.
DOI : 10.1002/pen.20285

D. C. Cheng, Yield stress: A time-dependent property and how to measure it, Rheologica Acta, vol.14, issue.5, pp.542-554, 1986.
DOI : 10.1007/BF01774406

H. A. Barnes, The yield stress???a review or ????????????? ????????????everything flows?, Journal of Non-Newtonian Fluid Mechanics, vol.81, issue.1-2, pp.133-178, 1999.
DOI : 10.1016/S0377-0257(98)00094-9

A. Ghanbari, M. Heuzey, P. J. Carreau, and M. , Morphological and rheological properties of PET/clay nanocomposites, Rheologica Acta, vol.38, issue.1, pp.59-74, 2013.
DOI : 10.1007/s00397-012-0667-1

H. M. Laun, Orientation effects and rheology of short glass fiber-reinforced thermoplastics, Colloid & Polymer Science, vol.26, issue.4, pp.257-269, 1984.
DOI : 10.1007/BF01410464

D. Guzm-an and J. , Relaci on entre la Fluidez y el Calor de Fusion, An. Soc. Esp. Fis. Quim, vol.11, pp.353-362, 1913.

H. Eyring, The Activated Complex in Chemical Reactions, The Journal of Chemical Physics, vol.3, issue.2, pp.107-115, 1935.
DOI : 10.1063/1.1749604

H. Eyring, Viscosity, Plasticity, and Diffusion as Examples of Absolute Reaction Rates, The Journal of Chemical Physics, vol.4, issue.4, pp.283-291, 1936.
DOI : 10.1063/1.1749836

S. Tiptipakorn, S. Rimdusit, S. Damrongsakkul, and T. Kitano, Thermomechanical and Rheological Behaviours of Waste Glass Fibre-Filled Polypropylene Composites, Engineering Journal, vol.13, issue.3, pp.45-59, 2009.
DOI : 10.4186/ej.2009.13.3.45

M. A. Islam and K. Begum, Rheological behavior of coir-fiber-filled polypropylene composites at constant shear stress, Polymer Composites, vol.29, issue.8, pp.51-61, 2015.
DOI : 10.1002/pc.22912

Y. Feng, D. Zhang, J. Qu, H. He, and B. Xu, Rheological properties of sisal fiber/poly(butylene succinate) composites, Polymer Testing, vol.30, issue.1, pp.124-130, 2011.
DOI : 10.1016/j.polymertesting.2010.11.004